KM RC Afterburner

Beskrivelse

En fantastisk bra universal  afterburner for INRUNNER motorer.

Info kommer.

Note: The LED lamp must be used at the same time as the power fan because the lamp is high brightness and the temperature will rise, requiring EDF power wind heat dissipation

Do not use in the case of no heat will cause overheating burn must be used in the case of heat dissipation!

Two-color specification

Added six light fusion modes. Default yellow-blue blend 2.

Setting method: The throttle is set to zero and switch by pressing the button. After the switch is successful, the red light is on and off once as an indication.

The idle speed blinks. Open by default.

Setting method: Hold down the button for three seconds, and the red light flashes to turn off/turn on idle. Press and hold once to close and again to open.

Low voltage alarm function, open by default. When the voltage of a single battery is lower than the set voltage and continues for 5 seconds (during 5 seconds, any time greater than the set voltage will be re-timed to prevent voltage transient fluctuations caused by acceleration or deceleration of the throttle), the taillight light starts to blink, and flashes once a second to stop blinking immediately after the voltage recovers.

Setting method: If the throttle is greater than 5%, press the button once to switch the voltage.

Blinking red once: The low voltage alarm is off. Blinking red is 3.3V twice for three times. Blinking red is 3.4V four times. Blinking red is 3.5V five times

1, pure yellow 2, yellow and blue mixed finally purple 3, yellow and blue mixed finally pink 4, yellow and blue mixed blue lights start the final pink 5, yellow and blue mixed yellow and blue at the same time linear maximum 6, pure blue